-
Lauxes Grates Waste Corner Joiner 90° PairVendor:
Create 90° corner transitions in Lauxes grates with rustproof anodised aluminium joiners. Available in Silk silver, midnight black, matte and gold.- $16.00
- $16.00
- Unit price
- per
-
Lauxes Grates End CapsVendor:
End Caps for Lauxes Grates in Silk Silver, Midnight Black, and Matte Gold. Rustproof aluminium with lifetime warranty. Fits all standard grate models. Sold in pairs.
- From $8.50
- From $8.50
- Unit price
- per
-
Lauxes Grates Pop Waste OutletsVendor:
Use Lauxes Grates Pop Waste Outlets for connecting linear grates to waste lines. The anodised aluminium construction ensures a lifetime rustproof performance in wet areas, compatible with 40mm, 50mm, 72mm, and 80mm PVC pipework.
- $11.67
- $11.67
- Unit price
- per
-
Lauxes Grates TCT Hole Saws For Pop Waste OutletVendor:
Use Lauxes Grates TCT Hole Saws for precise, burr-free holes in aluminium Lauxes grates. TCT teeth provide up to 10x longer life than standard bi-metal saws and come as a complete unit with a pilot drill for immediate use on site.
- From $36.67
- From $36.67
- Unit price
- per
-
Lauxes Grates Waste Joiner 180° PairVendor:
The Lauxes Waste Joiner 180° Pair is an essential accessory for expanding your Lauxes grate drainage system around corners.
- $16.00
- $16.00
- Unit price
- per
-
Megaflex™ Puddle FlangeVendor:ART AustraliaUse Megaflex™ Puddle Flange to create a watertight seal at pipe penetrations in concrete slabs. Its high-grade PVC design acts as a water-stop, preventing moisture tracking, compliant with AS/NZS 1260.
- From $7.68
- From $7.68
- Unit price
- per
Frequently Asked Questions
What are these fittings for?
They connect and finish a drainage run. End caps close a channel, joiners turn or extend it, pop waste outlets couple it to the pipework, and a puddle flange seals the membrane where the pipe goes through the slab. They complete the drain, not replace it.
What does a puddle flange do?
It seals the gap where the waste pipe penetrates the slab, so water cannot track back under the waterproofing membrane. The Megaflex puddle flange is WaterMark certified. Match it to the pipe size and the membrane detail.
Why would I need an end cap?
To close the open end of a linear channel. Without one, water can run out the end and behind the wall or the adjoining floor. The Lauxes end caps are sealed at the channel-to-cap joint. Match the cap to the channel profile.
What do the joiners do?
The 180-degree joiners connect two channels in a straight line. The 90-degree joiners turn a corner. They let you build a run longer or around a bend than a single channel allows. Match the joiner to the channel model.
Why is a hole saw listed here?
To cut the outlet hole in the bottom of a Lauxes channel tray. It is an installation tool for the job, not a drain. Use it to set the outlet where the channel meets the waste.
- Choosing a selection results in a full page refresh.