13
Trade quote
Custom pricing available
Tell us what you need and we'll come back with a quote.
Custom trade quote
Share your quantity and project details for a tailored quote.
Lauxes Grates Waste Corner Joiner 90° Pair is an anodised aluminium drainage component designed for creating structural 90-degree transitions in linear grate systems. This mechanical fit system eliminates the need for manual mitre-cutting and adhesive curing, ensuring flush substrate alignment and long-term resistance to salt and UV in coastal or poolside environments.
The construction supports AS/NZS 3500 compliance and is backed by a Lifetime Rustproof Warranty to prevent joint failure or oxidation.
Frequently Asked Questions About Lauxes Waste Corner Joiner 90° Pair
Q: Do these joiners fit all Lauxes grates?
A: Yes, the 90° joiners are compatible with a wide range of Lauxes grate profiles including NXT, ST, SFG, and more. Always confirm your profile before purchase.
Q: Can they be used for outdoor installations?
A: Yes, they are ideal for outdoor use. The anodised aluminium construction resists rust and corrosion even in coastal and wet conditions.
Q: Is silicone required during installation?
A: No, the joiners fit securely without adhesives. However, in high-moisture or sealed environments, silicone may be used for added protection.
Q: Can I adjust the angle from 90°?
A: No, these joiners are fixed at 90° only. For other angles, custom cutting of the grates will be required.
Q: Do I need special tools for installation?
A: Just a rubber mallet and measuring tape. A mitre saw may be needed if the grate requires trimming before inserting the joiners.
Use Lauxes Waste Corner Joiner 90° Pair for:
- Balcony drainage corners
- Poolside and outdoor paving transitions
- Bathroom and wet area 90° installations
Why Use Lauxes Waste Corner Joiner 90° Pair for:
- Seamless corner transitions without onsite cutting
- Superior corrosion protection even in coastal areas
- Time-saving installation with architectural consistency
How to apply 90° Aluminium Joiners:
- Mark the 90° corner and trim the Lauxes grate ends as required using a mitre saw or aluminium cutter.
- Dry-fit the joiners to confirm correct alignment and flow direction.
- Tap the joiners into the ends of the grates using a rubber mallet for a snug fit.
- Check water flow and alignment before securing final installation.
Lauxes Waste Corner Joiner 90° Pair limitations:
- Only suitable for 90° connections—does not support other angles
- Designed specifically for use with Lauxes grate systems
Safety precautions when using Lauxes Waste Corner Joiner 90° Pair:
- Personal Protective Equipment: Use gloves and eye protection when cutting aluminium grates
- Ventilation: Not applicable—no solvents or adhesives used
- Handling: Avoid sharp edges; use tools to reduce hand strain
- First Aid: Clean and dress any cuts immediately with antiseptic
90° Aluminium Joiners can be used on the following substrates:
- aluminium — matches anodised Lauxes grates
- anodised aluminium — perfectly compatible with all Lauxes profiles
- Choosing a selection results in a full page refresh.